Halloween Moon Shadows - Coup & Decal

The structured monomer PVC film permits an easy installation without turnaround risks. Its thickness of 80µ makes it almost undetectable to the touch. Stained in the mass with a matt finish it ensures a perfect rendering.

The removable polyacrylate adhesive of the film with a durability of 3 years guaranteeing a steady installation of the sticker while allowing a simple removal without residue of glue.

You don't know how to configure your sticker or you have a doubt : contact us we will achieve your order together.

The installation of the film is done in a simple way:

• Pass an applicator (or a simple rigid card) on the tape (visible side of the sticker) with an average pressure to avoid any bubble
• Do the same on the back of the sticker
• Remove the liner from the sticker (not visible side of the sticker)
• Hang the tape at two opposite angles and present the sticker on the surface to be covered without touching it to position the sticker at the desired location.
• Once satisfied with the position, stretch the stroke and apply the angles on the same side to the surface to be covered.
• Retain the tape to check the position, then with a squeegee, or the flat of the hand, slide to the opposite side of the laid side. In case of deviation, it is preferable to remove the assembly and modify the surface of the angles already fixed.
• The position of your sticker is ok for you? Put a squeegee (or a rigid card) on the tape + sticker on the surfaces of the sticker without making any contradictory movements.
• Remove the tape from an angle (two if the sticker size is large)
• It remains only the sticker, to verify that it's adhering well everywhere if not pass one finger on the surfaces that bullen.

Removing the film is just as easy:

• With one nail or one fine and soft squeegee gently lift a protruding angle of your sticker to lift a part (do not scratch).
• Once the raised surface is sufficient to hold it with two fingers, pull inward of the display.
• If the film separates, repeat the previous two actions.
• Once the sticker has been removed, there should be no trace of glue, however, it can remain a dust mark, then wipe the surface with the sticker with a soft dry cloth.
• In case of adhesive residue (this can happen after 2 years of installation), use a cleaning cloth dedicated to the computer.

Product made and printed in France at Saint-Clair-du-Rhône (38 - Isere)